What to do if Spectra Logic Storage has problems reading and writing data?
If you are experiencing issues with reading and writing data, consider the following: * Ensure the cartridge is write-enabled before importing it into the library. * If the cartridge is old, try using a new one. * Clean the tape drive(s).
What to do if Spectra Logic Storage has sporadic errors when using direct-attach SCSI tape drives?
If you encounter sporadic errors, ensure that the SCSI bus connected to each tape drive is properly terminated at both ends.
What to do if Spectra Logic T Spectra T50e Storage additional devices on the SCSI bus are not properly terminated?
Ensure that only the devices at the two physical ends of the bus are terminated.
What to do if Spectra Logic T Spectra T50e LTO-4 tape drive has SCSI connection issue?
Connect a wide Ultra 3 Active SCSI terminator to the second SCSI connector on the tape drive; do not daisy-chain LTO-4 SCSI tape drives.
General| Category | Tape Library |
|---|---|
| Tape Technology | LTO |
| Drive Slots | 2 |
| Number of Slots | 50 |
| Interface | SAS |
| RAID Support | No |
| Connectivity | SAS |
| Operating System Compatibility | Windows, Linux |
| Supported Media | LTO-7, LTO-8 |
| Power Supply | Dual redundant power supplies |
| Encryption | Yes, AES 256-bit encryption |
| Form Factor | Rack-mountable |
| Number of Drives | Up to 2 |
To Next Page
