Spectra Precision HL760 - HL760 General Operation; Remote Operation Mode Setup

HL760: General Operation
Remote Operation
 Turn both HL760’s Off.
 The first HL760 turned on becomes the laser SENSOR
(receiver).
 The second HL760 turned on becomes the REMOTE
DISPLAY / CONTROL PANEL
 Turn on the HL760 that is desired to be the SENSOR
first.
 Turn on the HL760 that is desired to be the REMOTE
DISPLAY / CONTROL PANEL second.
 RMT.D – OK (flashing) will be displayed.
 Press ENTER to operate this HL760 as the REMOTE
DISPLAY / CONTROL PANEL.
NOTE: If ENTER is not pressed, both HL760’s will
revert to standard operation.