Rotation mode using the RC402N
Press and release the button and select >>Rotation<<.
Press and release button to display the actual rotation
speed.
Use the buttons to select toggle through the pre-
selected rotation speeds 0, 10 (short moving line),
80, 200 and 600 rpm.
Confirm the desired speed by pressing the button.
When set up horizontally in automatic mode, using the
buttons increase/decrease the rotor speed from 10 to 80
and then continuously in 10 rpm increments up to 600 rpm.
Pressing button shows the actual rpm.
At 0 rpm, the beam stops automatically close to the
+Y- axis center position. Buttons move
the beam to the Left/Right side.
Note: To stop the beam’s rotation immediately, press and
release the laser’s button.
To Next Page
Loading...
