Spectra Precision HV302 - Scan mode using the RC402 N; RC402 N Scan Control

Scan mode using the RC402N
 Press and release the button and select >>Scan<<.
 Press and release button to display the actual scan
size.
 Use the Up/Down buttons to toggle through the
pre-selected scan sizes 5°, 15°, 45°, 90°, 180°and 0.
 Confirm the desired scan size by pressing the button.
 When set up horizontally in automatic mode, using buttons
increase/decrease the scan size in 5°increments.
Pressing button shows the actual scan size.
Press and hold button moves the scan line to the
right/left direction. In automatic vertical mode, pressing and
holding button moves the scan line counterclockwise/
clockwise; buttons moves the scan line into the right/left
direction regardless if in automatic or manual mode.
Note: To stop the scan mode immediately, press and release
the laser’s button.