Flange
Silicone valve
.
-4 -
.
• Wash your hands thoroughly and dry completely before using the product.
Before you begin pumping, make sure your breasts are clean.
• Make sure that you have correctly washed, sterilized and assembled the
pump before use.
CaraCups assembly instructions
Valve connector
Membrane
Backflow
prevention cap
Membrane
Ensure that the
convex side is
facing down.
View from above
after assembly
1. Prepare the valve connector, membrane
and backflow prevention cap.
2. Assemble in the order of valve connector,
membrane and backflow prevention cap.
3. Align the flange to the assembled valve
connector so flange should be lined up to
the tubing connect hole of the valve
connector.
4. Press the flange and the assembled valve
connector together firmly with both
hands.
5. Attach the silicone valve to the valve
connector.
6. Align the milk collection cup to the
previously assembled parts and join
them.
7. Connect the tubing to the assembled
CaraCups.
8. Check that the tubing is connected
properly.
To Next Page
Loading...
