14205603-IG, Edition 11.0
May 2020, Original document
21
Adding DECT Handsets to CUCM Database
This section describes how to add the individual Spectralink DECT Handsets to the Cisco Unified
Communications Manager.
Each individual DECT handset is identified by a unique IPEI number, which is generated by the
Spectralink IP-DECT/DECT/Virtual IP-DECT Server. This IPEI number can be compared to the
MAC address, which identifies the Cisco IP Phones. The IPEI number of a specific DECT handset
can be viewed by editing the user in the Spectralink IP-DECT/DECT/Virtual IP-DECT Server.
Two different methods for adding handsets are supported:
l Manual end user/handset creation
l Automated end user/handset provisioning using the Bulk Administration Tool
Manual End User/Handset Creation in CUCM
Manual handset creation consists of the following two tasks:
l Adding new end users manually
l Adding handsets manually
To Add End Users Manually
1. Navigate to Cisco Unified CM Administration > User Management > End User.
2. Click Add new.
3. On the End User Configuration page, enter relevant data in the following fields:
Field Setting
User Information
User Id Enter the relevant user ID. E.g. rchristensen
Password Enter a password.
(If you are LDAP integrated, this field will be
grayed out and unavailable, and you would cre-
ate or modify this password through the Active
Directory Server. This password is not used by
the Spectralink IP-DECT/DECT/Virtual IP-
DECT Server, but it is good practice to assign a
password for each user).
Confirm Password Confirm the password.
Spectralink IP-DECT Server 200/400/6500, Virtual IP-DECT Server One and DECT Server 2500/8000 Interoperability Guide
To Next Page
Loading...
