2-2 Chapter 2: Installing a ControlLogix 1756sc-CTR8-SC Module
Owner’s Guide 0300199-01 Rev. D
If this product bears the CE marking, it is approved for installation within the
European Union and EEA regions. It has been designed and tested to meet the
following directives.
This product is tested to meet Council Directive 2014/30/EU Electromagnetic
Compatibility (EMC) and the following standards, in whole or in part,
documented in a technical construction file:
• EN 61000-6-4 Electromagnetic compatibility (EMC)–Part 6-4: Generic
standards–Emission standard for industrial environments.
• EN 61000-6-2 Electromagnetic compatibility (EMC)–Part 6-2: Generic
standards–Immunity for industrial environments.
UKCA Electromagnetic Compatibility Regulations 2016
• BS EN 61131-2, BS EN 61000-6-4, BS EN 61000-6-2.
This product is intended for use in an industrial environment.
This product is tested to meet Council Directive 2014/30/U/ATEX, and the
following standards, in whole or in part, documented in a technical construction
file:
• EN 60079-0 Explosive atmospheres–Part 0: Equipment – General
requirements.
• EN 60079-7 Explosive atmospheres–Part 7: Equipment protection by
increased safety "e".
This module also meets the standards for the United Kingdom Equipment and
Protective Systems Intended for use in Potentially Explosive Atmospheres
Regulations 2016:
• BS EN 60079-0.
• BS EN 60079-7.
This product is tested to meet Council Directive 2014/35/EU Low Voltage, by
applying the safety requirements of EN 61010-2-201 Safety Requirements for
Electrical Equipment for Measurement, Control, and Laboratory Use - Part 2-
201: Particular Requirements for Control Equipment.
For specific information required by EN 61010-2-201, see the appropriate
sections in this publication, as well as the following Allen-Bradley publications:
• Industrial Automation Wiring and Grounding Guidelines For Noise
Immunity, publication 1770-4.1
• Automation Systems Catalog, publication B111.
To Next Page
Loading...