13
Relative Water Content Set Points: Up to 2 Relative
Water Content (see p. 10) modes can be programmed into
the meter by entering the wet and dry set points into the
appropriate boxes. From the dropdown menus near the
bottom of the screen, select which VWC calibration
(Standard or High Clay) should be used for each RWC
mode. Each of these modes can be given a descriptive
name of 5 characters. These names can be used to identi-
fy a certain field or soil type.
Finally, for an RWC mode to be available, it must be ena-
bled by checking the Enable Display box. If this box is
not checked, that RWC mode will not appear on the LCD
during meter operation.
To Next Page
Loading...
Need help?
General
