4
Meter Operation
Press the READ button to read the probe
and update the screen values. The data
point can be cleared from memory with
the DELETE/CLR AVG button (below).
READ
When the DELETE/CLR AVG but-
ton is pressed and immediately re-
leased, the last data point will be re-
moved from the running average.
Pressing and holding this button will
reset the running average.
Delete
Clr Avg
The ON switch turns the meter on and
off. When the meter is turned on, it will
display the battery status for 3 seconds.
The screen will then display the most
recently used MODE screen
(Volumetric or Relative water content or
measurement period). The data screens for the Water
Content Modes are explained on pages 8 and 10. The Peri-
od mode is used for doing soil-specific calibrations and is
explained on page 14.
ON
Battery at 85%
Firmware V5.0
Stndrd VWC%=27.1
PL=M N008 A=26.5
Sample meter power-up
and data screens
Period = 0950 uS
N015
Pressing the MODE button allows the
user to determine the type of measure-
ment that will be taken or select the
length of rods connected to the probe.
MODE
To Next Page
Loading...
Need help?
General
