© 2018 All Rights Reserved.
5
Specifications
Motor/ Power Requirements (115 V Model) 3/4 HP AC Motor (1φ) / 115 VAC / 12.5 Amps
Motor/ Power Requirements (230 V Model) 1 HP AC Motor (1φ) / 230 VAC / 5.7 Amps
Water Requirements 2.5 Gallons per Minute (2 GPM 50 Hz)
Maximum Inlet Water Pressure 100 PSI (6.8 BAR)
Maximum Output Water Pressure 400 PSI (27.2 BAR)
Weight 35 lbs
Maximum Inlet Water Temperature 125°F (52°C)
Maximum Ambient Operational Temperature 104°F (40°C)
PROBLEM PROBABLE CAUSE REMEDY
Inconsistent and/or
erratic pressure
• Nozzle clogged
• Inadequate water supply
• Clean nozzle orifice
• Ensure 2.5 GPM minimum
Motor stops abruptly • Motor thermal
breaker tripped
• Turn off, let unit cool
Motor buzzes but fails to start • Inadequate power supply • Check for proper
voltage/current
Unit does not spray chemical • Siphon injector clogged
• Pickup hose not in chemical
• Inspect and clean siphon
• Put hose to bottom
of chemical
Accessory/Spare Part Part #
15° Cleaning Nozzle (Yellow)
CJ-QDN-1508Y
25° Cleaning Nozzle (Black)
CJ-QDN-LP25
Spray Gun Assembly (with 18” Lance Attached) CJ-RCC-23
Primary Hose Assembly – Connects to Pump (12 ft) CJ-RCC-13
Extension Hose Assembly (12 ft) CJ-HF-EXTHOSE
Spray Gun Assembly without Lance (optional) SC-RCC-14
18” Extension Wand (optional) CJ-9655
40” Condenser Needle — Sectional Two Piece (optional) SC-WWSS-HF
Replacement Water Seal Kit for Pump RCC-09-SK
Troubleshooting
Accessories/Spare Parts
FlowJet-60
To Next Page
Loading...