Easy Flash Module 3.0 User Manual
EFM 3.0 V1.1 Speed Turtle Engineering LLC Page | 3
Preface
This manual describes the features and operation of the Easy Flash Module 3.0 (EFM 3.0)
with software version V3.00. Speed Turtle Engineering recommends you always run the latest
available EFM 3.0 software. The latest software is available for download at
SpeedTurtleEngineering.com. To check and update your module software version, use the STE
Configuration Utility program.
General Operation
The EFM 3.0 provides a simple and effective way to flash the factory exterior lights of
supported vehicles. The system is easily installed in minutes and is a true plug and play solution. If
equipped and supported, the module will flash the following lights:
- Front Low Beams
- Front High Beams
- Front Turn Signals
- Front Fog Lamps
- Front LED Accents
- Rear Turn Signals
- Rear Stop Lamps
- Third / Center Mounted Brake Lamp
- Reverse Lamps
- Pickup Bed Lamp
Unlike other solutions, the EFM 3.0 does not require any cutting or splicing of the vehicle’s
wiring harness. This allows the module to be easily installed by anyone in minutes. The plug and play
installation also allow the module to be removed and installed in another vehicle without repairing
or replacing vehicle components.
To Next Page
Loading...