2
Step 1 -
Take Wagon out of
Carton
Remove the wagon and its
pieces from the box. Make sure
you have all of the pieces. See
the parts list for reference.
Place the wagon bed upside
down, using the cardboard box
to protect the surface from
being scratched.
Step 2 -
Rear Support Assembly
Attach the rear axle support (2) to the bed using 16mm bolts (10),
6mm washers (11), 6mm Spring washers (12), and 6mm nuts (9).
Attach the left and right support braces (3, 4) and washer (8) on both
sides of the rear axle support (2) and attach to the wagon bed
(1) using bolts, washers, lock washers, and nuts.
Tighten all nuts securely.
customerservice@focus-ontools.com
1-800-348-5004
To Next Page
Loading...