EasyManuals Logo
Home>Spektrum>Receiver>SR2000

Spektrum SR2000 User Manual

Spektrum SR2000
12 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #5 background imageLoading...
Page #5 background image
EN
Aux channel
TheAuxchannelcanoperateasa3rdservochannel,orasapowersupplyfor
apersonaltransponder.If5.5msframerateisselectedinthetransmitter,only
two channels, Steering and Throttle, are operational. The Aux channel can be
used to power a personal transponder or lights.
Ifaframerateotherthan5.5msisselected,theAuxchannelwilloperateasa
3rdservochannel.
IMPORTANT: When using the receiver with a DSMR transmitter, you must
re-bind any time you change the frame rate in the transmitter.
NOTICE: TheDX3R,DX3RProandtheDX4RProarerequiredfor5.5msframerate.
Receiver Connection and Installation
Install the Receiver in your vehicle using double-sided foam servo tape. Foam
servo tape will hold the receiver in place and help isolate it from vibrations.
The receiver includes two pieces of double-sided foam tape. If you plan on
driving your vehicle in wet conditions, use the smaller piece of foam tape (A).
Otherwise, the larger piece of foam tape (B) prevents dust from entering the
receiver case.
Mount the antenna up and away from the vehicle in the included antenna tube.
The higher up the antenna is, the better signal it will receive.
NOTICE: Do not cut or modify the antenna.
Failsafe
The throttle failsafe position is set during binding. In the unlikely event that
the radio link is lost during use, the receiver will drive the throttle channel to
its pre-programmed failsafe position (normally neutral or full brakes). If the
receiver is powered on prior to turning on the transmitter, the receiver will enter
the failsafe mode, driving the throttle channel to its preset failsafe position.
When the transmitter is turned on, normal control is resumed.
IMPORTANT: Failsafe activates only in the event that signal is lost from the
transmitter. Failsafe will NOT activate in the event that receiver battery power
decreases below the recommended minimums or power to the receiver is lost.
Drain holes
A
B

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Spektrum SR2000 and is the answer not in the manual?

Spektrum SR2000 Specifications

General IconGeneral
BrandSpektrum
ModelSR2000
CategoryReceiver
LanguageEnglish

Related product manuals