EN
6
Problem Possible Cause Solution
The system will
not connect
You are near metal objects Move to an area with less
metal
The receiver is bound to a
different model memory
Make sure the correct
model memory is active in
your transmitter
Your transmitter was
placed into bind mode and
is no longer bound to your
receiver
Rebind your transmitter
and receiver
The receiver
goes into
failsafe mode a
short distance
away from the
transmitter
The antenna inside the
receiver case could
become damaged if the
receiver is damaged
Inspect the receiver for
damage
Replace the receiver or
contact Horizon Product
Support
The receiver
stops respond-
ing during
operation
Low receiver battery volt-
age. If the battery voltage
is low, it may drop below
3.5V momentarily, causing
the receiver to brown-out,
then reconnect
Charge the receiver or
vehicle battery. Spektrum
receivers require at least
3.5V to operate
Loose or damaged wires
or connectors between
battery and receiver
Check the wires and
connection between the
battery and receiver. Repair
or replace wires and/or
connectors
Troubleshooting Guide
To Next Page
Loading...
Need help?
General
