EasyManua.ls Logo

Spinlock deckvest 5D - Important Considerations; Major Falls; Cleaning, Maintenance, and Storage

Default Icon
60 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
LIFETIME = SHELF LIFE + USEFUL LIFE
After rst use this product should last 5 years.
Certain environmental elements will considerably
accelerate wear: salt, sand and chemicals. In
exceptional circumstances, wear or damage could
occur on the rst use which reduces the lifetime
of the product to that one, single use. Wear or
damage can shorten the product life. Shelf-life
of this product in good condition is up to 5 years
before rst use.
TEMPERATURE
Use this product only above a minimum of -30°
C and below a maximum of +60° C. When the
temperature is below freezing, even a fully charged
cylinder may not adequately inflate your lifejacket.
If this occurs use the oral tube to manually top up
your lifejacket after the CO
2
has been discharged
(and not before).
DISINFECTING THE PRODUCT
When necessary, use a disinfectant that
is compatible with polyamide, polyester,
polycarbonate, PVC etc. Use diluted with clean
water at a maximum temperature of 30° C. After
soaking for an hour, rinse in clean cold water. Dry
slowly, away from direct heat.
MAJOR FALLS
In the event that your full body weight is dropped
a distance and then stopped, do not continue to
use this product. Even if no external changes are
visible, internal damage may have reduced its
strength and its margin of safety. Do not hesitate
to contact Spinlock in case of doubt.
CLEANING, MAINTENANCE, STORAGE
Remove gas cylinder and automatic components
and then clean by hand and rinse in clean fresh
water (maximum temperature 30° C). Dry in a
cool, ventilated dark room. Grease spots may be
removed with trichlorethylene. Webbing shrinks
very slightly in drying. Always carry and store
your Deckvest in a well ventilated bag. Though UV
protected, this product is best stored away from
direct light, in a well ventilated place away from
extreme temperatures.
CHEMICALS
All chemicals (including petrol, battery acid,
corrosive materials and solvents) should be
regarded as harmful. If your Deckvest comes in
contact with chemicals, please notify Spinlock,
stating the precise chemicals concerned. We will
investigate and give our advice.
WARNING: The deck safety harness and safety
line are intented to prevent the user falling
overboard. They do not provide protection
from falls at height. For full guidance on the
use of the safety cutter please visit: www.
spinlock.co.uk
WARNING: Some dye may transfer when rst
used in wet conditions, we advise against rst
using your Deckvest with light coloured jackets.
15

Other manuals for Spinlock deckvest 5D

Related product manuals