Motor T and B Buttons
The motor T and B buttons will activate (pop out) if the machine detects a
ball jammed inside the machine.
When activated, the button pops out approximately 6 mm. In the event the
button is activated, turn off the power and push the button back in. Wait
for the service wheels to stopped spinning and then check and remove any
balls jammed inside the machine. Turn the power back on to resume normal
operation.
Remote Watch
The remote watch is an optional accessory. The watch requires a CR2032
battery to be tted.
Switch on the machine and then press the remote watch button to connect.
The red light will blink while the watch is trying to connect to the machine.
The red light will go out once the machine is connected.
When the button is pressed the light will ash once to indicate the command
has been sent.
If the red light starts blinking this indicates the signal has been lost and it
is trying to reconnect. If the machine is turned off the remote watch will go
into sleep mode.
Remote Watch Functions
The remote watch can be used to start and stop the ball feed and switch
between drills.
Starting or Stopping the Ball Feed
A long press (over two seconds) on the remote watch button will start and
stop the ball feed.
Switching Between Drills
A short click of the remote watch button selects the drill number equivalent
to the number of clicks. ie, 2 clicks = Drill #2, 12 clicks = Drill #12.
4
To Next Page
Loading...
