followed by lobs.
3. Each time when the user presses the oscillation button to enter a
different oscillation mode, there will be a default setting shown in
the LCD. Such a setting is the preferred value for the
corresponding oscillation mode.
4. Keep pressing the “+” or “-“ button will continuously increase or
decrease the selected values.
5. By properly positioning the machine, the user can make the
machine shoot balls evenly across the court during horizontal
oscillation modes.
6. The maxim feed rate setting is 9, but in oscillation mode, the feed
rate can be lower than in manual mode due to internal height or
horizontal motor adjustment delay.
7. The serving wheels can not slow down quickly. So in vertical
oscillation mode, when machine switches from low shots to higher
shots with a high spin setting it will produce shots out the back of
the court if it is used with fast feed rates.
8. The high top spin setting will slow down the balls. Therefore, when
machine works with high spin setting, it is suggested that the
machine be set to a high speed level of over 17. Default speed
setting will be 20 for spin level higher than 7.
9. When machine switch between different oscillation modes, it could
be possible that machine shoot initial 2 or 3 balls not very precisely
during its calibration stage. After such stage, the machine will
precisely shoot balls at defined setting.
Battery Charging (for Battery Model)
You need to first connect the battery charger to a live electrical outlet
and then insert battery charger into the socket labeled as “CHARGER”
on the control panel.
The battery will be fully charged in 8 to 15 hours. The LED light on the
charger pack will be green when the machine is fully charged. If LED
stays red, the charging process is still continuing. A fully charged
To Next Page
Loading...