Local regulations may restrict the use of this product to below the conditions quoted.
In the interests of development and improvement of the product, we reserve the right to change the specification without notice. © Copyright 2014
Page 1 of 3
TI-P358-28
CH Issue 3
Accessories
for the AEL5 Series
of Electric Linear Actuators
Available types and technical data
AEL5961 230 Vac positioner card Power consumption 1 VA
AEL5962 115 Vac positioner card Power consumption 1 VA
AEL5963
24Vac positioner card (except for
AEL54213
_
, AEL55313
_
and AEL56413
_
)
Power consumption 1 VA
AEL5964
24 Vac positioner card (for AEL54213
_
,
AEL55313
_
and
AEL56413
_
actuators only)
Power consumption 1 VA
AEL5951 2 auxiliary limit switches (Electronic card) 5 A - 230 Vac - including cams, mounting kit and PCB
AEL5952 Auxiliary feedback potentiometer 1000 ohms, 20 to 30 mm stroke, including mounting kit and pinion
AEL5952.1 Tandem feedback potentiometer 2 x 1000 ohms 20 to 30 mm stroke, including mounting kit and pinion
AEL5952.2 Tandem feedback potentiometer 2 x 1000 ohms 25 mm maximum stroke, including mounting kit and pinion
AEL5952.3 Auxiliary feedback potentiometer 2000 ohms 20 to 30 mm stroke, including mounting kit and pinion
AEL5952.4 Tandem feedback potentiometer 2 x 2000 ohms 20 to 30 mm stroke, including mounting kit and pinion
AEL5952.5 Auxiliary feedback potentiometer 500 ohms 20 to 30 mm stroke, including mounting kit and pinion
AEL5953 Tandem feedback potentiometer 2 x 1000 ohms
20 to 30 mm and 30 to 50 mm stroke,
including mounting kit and pinion
AEL5954 115 - 230 V anti-condensate heater
AEL5956 24 V anti-condensate heater
AEL5981 Position transmitter 2 wire 4 - 20 mA
AEL5982 Position transmitter 3 wire 0 / 4 - 20 mA
The potentiometer must use its whole range (almost 1 full turn). To facilitate different actuator strokes replacement pinion kits are
available. Please contact Spirax Sarco for further information.
Special parts
Pinion 25 teeth with AEL5
_
For stroke <= 20 mm
Pinion 30 teeth with AEL5
_
For stroke between 20 mm to 30 mm
Pinion 50 teeth with AEL5
_
For stroke between 30 mm to 50 mm
Pinion 65 teeth with AEL5
_
For stroke between 50 mm to 65 mm
Pinion 75 teeth with AEL5
_
For stroke between 65 mm to 70 mm
For information on AEL5 series actuators see TI-P358-25
To Next Page
Need help?
General