Spirit CG800 e - Pre-Assembly; Assembly T Ools

3
e
Glide Trainer
CG800
Assembly Tools
1. Using a razor knife (Box Cutter), cut the banding straps that wrap around the carton. Reach under the bottom
edge of the carton and pull it away from the cardboard underneath, separating the staples that join the two
together. Lift the box over the unit and unpack.
2. Carefully remove all parts from carton and inspect for any damage or missing parts. If damaged parts are
found, or parts are missing, contact your dealer immediately.
3. Locate the hardware package. The hardware is separated into four steps. Remove the tools rst. Remove the
hardware for each step as needed to avoid confusion. The numbers in the instructions that are in parenthesis
(#) are the item number from the assembly drawing for reference.
Pre-Assembly
#115. Phillips Head
Screwdriver
#116. 8mm
Allen Wrench
#117. 17mm
Wrench
#118. 12mm
Allen Wrench
#119. 5mm
Allen Wrench
#120. 13/14mm
Wrench
CG800
Assembly Instructions