4
Glide Trainer
1. The resistance adjustment cable and speed sensor wire are pre-installed to the console mast and main frame so
be careful not to pull too hard on the console mast during assembly to avoid damaging them.
2. Lift the console mast (2) into place and align it so the locating pins in the mounting plate are set into the holes
in the mating plate of the main frame. Be careful not to pinch the speed sensor wire between the console mast
and the main frame plates during assembly.
3. Secure the console mast in place with the four stainless steel bolts (58) and split washers (65). Make sure the
bolts are fastened as tightly as possible.
4. Install the stationary handlebars (3) to the console mast (2) with four stainless steel bolts (129) and four split
washers (65). Make sure the bolts are securely tightened.
#58. M10 x 20mm
Stainless Steel Bolt
#65. M10
Split Washer
HARDWARE
#129. M10 x 25mm
Stainless Steel Bolt
STEP 1: Console Mast
To Next Page
Loading...