Spirotech SpiroVent Superior S600

To Next Page

User manual - 1.0 English 2

EnglishUser manual

TABLE OF CONTENTS

1PREFACE

1.1 About the device

This user manual describes the installation,

commissioning and operation of the following SpiroVent

Superior types:

1.2 About this document

Read the instructions before installation, commissioning

and operation. Keep the instructions for future reference.

The original language of the document is English. All

other available language versions are translations of the

original instructions.

The illustrations in this document show a typical setup

with relevant details for instructional use only.

Differences between the illustrations and the device are

possible but do not have an effect on the

comprehensibility of this document.

duplicated and/or made public through the Internet, by

means of printing, photocopying, microfilm or in any

other way without prior written permission from

Spirotech bv.

This manual has been composed with the utmost care.

Should, however, this manual contain any inaccuracies,

Spirotech bv cannot be held responsible for this.

1.3 Symbols

Throughout the instructions the following symbols are

used:

1Preface 2

2 Introduction 3

3 Technical specifications 7

4Safety 7

5 Installation and commissioning 8

6Operation 13

7 Failures 17

8 Maintenance 20

9 Guarantee 23

10 CE statement 24

Type Article code Description

S600 MV06A.. Automatic vacuum degasser

S600-R MV06R.. Automatic vacuum degasser,

including integrated refill

function with direct refill

connection.

S600-B MV06B.. Automatic vacuum degasser,

including integrated refill

function with backflow

prevention.

Warning or important note

Note

Risk of electric shock

Risk of burning

Main Page

Need help?

Do you have a question about the Spirotech SpiroVent Superior S600 and is the answer not in the manual?

Summary

INTRODUCTION

Overview of the unit

Diagram and list of components of the SpiroVent Superior unit.

Operation

Details the operation, including general, degassing, refilling, and remote monitoring.

Remote monitoring

TECHNICAL SPECIFICATIONS

General specifications

Operating characteristics

Details operating parameters such as pressure, temperature, and refill flow.

Electrical specifications

Covers supply voltage, current, power consumption, and fuse details.

SAFETY

Safety instructions

Refers to a separate document for detailed safety instructions and information.

INSTALLATION AND COMMISSIONING

Installation conditions

Specifies requirements for unit placement, ventilation, and connection.

Unpack

Mounting and installation

Details on mounting the unit and mechanical installation steps.

Commissioning

Filling the unit

Steps to fill the unit with water and equalize pressure.

First startup

Guide for connecting to power and initial setup, including language selection.

Check operation

Procedure to check the unit's operation after installation and filling.

OPERATION

HMI (user interface) description

Buttons and indicators

Settings

Configuration options for unit parameters and operation.

Switch on the unit

Change a setting

Switch off the unit

Operating mode

Refill

Manual refill

FAILURES

Remedy failures

General advice for handling failures and warnings.

Replace a fuse

Taking out of operation

Resetting the unit

Failure table

A table listing problems, possible causes, and corresponding corrections.

MAINTENANCE

Periodic maintenance

Replacement parts

GUARANTEE

Terms of guarantee