SPIT 372 - Technical Specifications; Tool Characteristics; Noise and Vibration Levels

Noise
Vibration
Declaration
of conformity
Measured values determined according to EN 60745. Typically the A-
weighted noise levels of the tool are:
Sound pressure level chisel: 1(97 + 3) dB(A) drill: 1(95 + 3) dB(A)
Sound intensity level chisel: (108 + 3) dB(A) drill: (106 + 3) dB(A)
Wear ear protection!
The typical weighted acceleration at rear handle is
18,8 m/s
2
(chisel) 18,7 m/s
2
(drill).
The typical weighted acceleration at front handle is
13,3 m/s
2
(chisel) 12,7 m/s
2
(drill).
We declare under our sole responsibility that this product is in con-
formity with the following standards or standardized documents:
IEC 60745-1, IEC 60745-2-6, EN 60745-1, EN60745-2-6, EN 55014,
EN 61000-3, EN 55104, in accordance with the regulations
73/23/EEC, 89/336/EEC, 98/37/EC
Didier BOURRETTE Jens STELLWAG
SPIT S.A., Route de Lyon - B.P. 104, F-26501 Bourg-les-Valence
8
Technical information
Characteristics
Tool fixing ……………………………………………………… S2S max
Voltage……………………………………………110 V …………230 V
Frequency ………………………………………………………50-60 Hz
Amperage ………………………………………10.8 A …………5.7 A
Power input………………………………………………………1250 W
Rotation speed ……………………………………………0 - 260 min
-1
Hammer rate strokes ……………………………………0 - 2700 min
-1
Impact energy ………………………………………………………10 J
Weight………………………………………………………………7.9 kg
Cable length …………………………………………………………4 m
Carbons ………………………………………………self-disconnecting
Lubrication …………………………………………………oil lubrication
Angle of chisel ………………………………………………8 positions
Switch ……………………………………………with electronic control
Class II …………………………………………………………………
Min. distance from the wall in order to drill ……………………39 mm
Dimensions (mm)………………………………………480 x 280 x 120