12
Operating instructions
To empty the container:
• Switch off the vacuum cleaner by moving the switch (2a) to ‘’0’’.
• Disconnect the electric cable (6) of the vacuum cleaner and
possibly the electrical tool cable from the socket.
• Move the vacuum cleaner to the refuse disposal area.
• Open the locking clips (9).
• Remove the upper part (1) and the suction pipe (15) from the
container (7).
• Tip up the container to empty it.
You can use big plastic bags to recover the dust (for instance: put the
container in the bag, and empty it into the bag)
Cleaning the filters:
When using the vacuum cleaner, in position ‘’1’’ or ‘’A’’, just move the
switch (2a) to ‘’RA’’. The electromagnetic vibrator is activated for 10
seconds and shakes off the dust sticking on the filters (12).
This operation should be performed latest when the airflow indicator (2c)
is activated, or when the suction capacity decreases.
In position ‘’AC’’, the vibrator starts automatically every 2 minutes of
actual work, as described previously.
Electromagnetic cleaning guarantees optimum use of the filters,
optimum suction, and optimised service life.
After working, you can also clean the filters with a smooth brush or, if
need be, with water. Leave the filters to dry, so that dust will not remain
stuck to them, before using them again
Emptying
the container
Minimum
cleaning and
maintenance
To Next Page
Loading...