Spitznas Maschinenfabrik GmbH, Fellerstr.4, D-42555 Velbert, Tel: +49(0)2052 605 0, Fax: +49(0)2052 605 29, www.spitznas.de
Translation of the original operation
manual, compiled: 21.03.13
512190010_BA_en_Version_02 Page 4 of 13
Secure the working place well. Use clamps or a vice to fix the work piece. This is
safer than using hands and clears both hands for operating the machine.
Hold the machine tight during operation.
Keep your working area clean and uncluttered.
Keep children away and avoid other persons to come into contact with the
machine.
Switch off the machine if it stops - for any reason - to avoid the unexpected
starting in uncontrolled condition.
Do not operate the tool if it is damaged, improperly adjusted or not completely
and correctly assembled.
Check hydraulic hose for damage.
During operation the saw blade has to be cooled, resp. lubricated, with emulsion
or oil.
Avoid sparks in hazardous environment - created by the saw blade. Always flush
material and saw blade for cooling with sufficient water during working.
Do not employ machines by excessive force. Their performance is better and
safer, if they work at the prescribed speed.
Check damaged parts.
Before using the machine, damaged parts or protective devices should be
carefully checked to make sure they work soundly and fulfil the designated
function. Check alignment, connections and attachment of moving parts. Also
check if parts are broken. Parts or protective devices that are damaged should, if
nothing else is mentioned in these operating instructions, only be exchanged or
repaired by qualified personnel. The same applies to defective switches and
valve triggers. If the machine cannot be switched on or off with the valve trigger,
it should not be used.
The use of other accessories, or other additional items than recommended in
these operating instructions, may include the risk of bodily injury.
Only operate the tool after a thorough training or under supervision of a trainer.
Never exceed the maximum operation pressure.
To Next Page
Loading...