Data di emissione: Maggio, 2016 Revisione: 6 Pag. : 54/64
Once performed all these cleaning and sanitizing
procedures, it’s possible to reassemble all the
components.
The correct assembly of the device is essential
to prevent leakage of product and damage of
the machine. To assemble the machine you will
need an approved lubricant (such as Vaseline).
Make sure all parts have been washed and
sanitized before assembling. Persons assembling
the machine must first wash and sanitize their
hands and forearms with an approved sanitizer.
- Spread Vaseline on the bell shaped seal
internal surface before reassembling it (fig.20).
- Reassemble the rear gasket and the bell
shaped one, respecting the correct direction as
indicated in figure 21.
- Reassemble the mixing unit making sure that
the frontal cylinder perfectly fit inside its
rotating shaft seat.
- Block all these components into place by
turning the knob in counter clockwise direction
(fig.22).
Fig. 20
Fig. 21
Fig. 22
To Next Page
Loading...
