Sports Attack ELITE E-HACK ATTACK - Error Codes

9
ELITE E-HACK ATTACK™ BASEBALL MACHINE
Sports Attack, LLC. | 800.717.4251 | www.sportsattack.com
Error Codes
WARNING
PERSONAL
INJURY HAZARD
Carefully read all instructions in
this manual, and all labels and
warnings on ELITE e-Hack Attack
before using this machine.
Use machine only under adult
supervision. Failure to operate
ELITE e-Hack Attack as described
in this manual can result in severe
personal injury or death.
ELECTRICAL
SHOCK HAZARD
The ELITE e-Hack Attack must be
connected to a properly
grounded electrical receptacle.
Do not operate on wet ground.
CAUTION
PERSONAL
INJURY HAZARD
Keep hands away from throwing
wheels anytime the machine is
connected to a power source.
Carefully check the ELITE e-Hack
Attack for completeness and
condition before connecting
to electrical power.
EQUIPMENT
ELECTRICALDAMAGE
Keep hands away from throwing
wheels anytime the machine is
connected to a power source.
Error Codes
Error 100: Actuator End of
Travel or Stall Condition
Detected. Repeat machine
set up with vertical actuator
closer to centered, adjusting
rear leg as required.
Conrmthereisnophysical
interference with pitching
head movement when
moving the head up and
down or side to side in the
manual pitch screen. If
problem persists, call Sports
Attack Technical Support.
Error 101: Motor 1 Fault Detected. Motor, drive, or wiring may be damaged.
Turn off machine and call Sports Attack Technical Support.
Error 102: Motor 2 Fault Detected. Motor, drive, or wiring may be damaged.
Turn off machine and call Sports Attack Technical Support.
Error 103: Motor 3 Fault Detected. Motor, drive, or wiring may be damaged.
Turn off machine and call Sports Attack Technical Support.
Error 104: Communication Error. Re-start machine. If error recurs, call Sports
Attack Technical Support.
Error 105: Pitch Ready Condition Timed Out. System did not reach
commanded pitch conditions in the expected period of time. Never pitch
a ball unless the green “Ready” indicator is displayed. Delayed time to
ready condition can be caused by excessive temperatures, physical
obstructions, undervoltage power, a faulty motor/drive, brake resistor
damage/overheat, or disconnected motors/actuators. If error recurs, check
that all motors/actuators are properly connected at the back of the control
box. If error recurs after checking connections, turn off machine and allow
to cool. If error continues to recur, call Sports Attack Technical Support.
Error 201: Motor 1 Over Temperature Shut Down. Warning Do Not Touch
Hot Motors! Turn off machine and let cool before re-starting. Operation
will return to normal after the motor cools. If error recurs, call Sports Attack
Technical Support.
Error Codes Page