To Next PageTo Next Page
What to do if SportsArt Fitness 6300 display shows no HR value?
If the HTR board LEDs are functioning normally, check the 3-pin cable, its connections, and the display board to resolve the issue of the display not showing an HR value.
Why is the LED1 (POLAR) not flashing on my SportsArt Fitness 6300?
If the LED1 (POLAR) is not flashing, it could be that the POLAR receiver isn't detecting a heart rate, or the signal isn't reaching the HTR board. Inspect the POLAR transmitter, POLAR receiver board, and the wires to resolve this.
How to fix LED2 (HTR) not lighting on SportsArt Fitness 6300?
The LED2 (HTR) might not be lighting up because the HTR handlebar isn't being held, or there's no signal detection at the HTR board. Inspect the HTR handlebar and the wire connecting the HTR board to the handlebar.
What to do if LED3 (HTR) is not flashing on SportsArt Fitness Treadmill?
If LED3 (HTR) isn't flashing, it indicates that the signal isn't arriving from the HTR handlebars. Inspect the HTR handlebar, cable, and HR board.
General| Brand | SportsArt Fitness |
|---|---|
| Model | 6300 |
| Category | Treadmill |
| Language | English |
Essential safety rules for treadmill operation, user conduct, and equipment checks.
Advisories on exercise limits, physician consultation, and electrical safety.
Initial assembly steps including checks, tipping, and upright post installation.
Guide on starting, entering user data (age, weight), and setting time.
Detailed steps for adjusting belt tension and alignment using adjustment bolts.
Explanation of error codes (E-1, E-3, E-7, E-6) and the 'Service Required' indicator.
Steps to troubleshoot and replace the fuse for the incline system.
Procedure for diagnosing and replacing the main fuse when the unit is unresponsive.
