13Springfree™ Trampoline Model SF90E Trampoline and Enclosure Assembly, Installation, Care, Maintenance and Use Instructions Version 6.4
Step 12: Attaching the rst rods to
the mat
Choose the rods on either side of a joint in the
frame. Connect the ball ends of these two rods
to two adjacent ttings in the mat.
Step 11: Laying down the mat
When all rods are in place, put the mat inside
the frame with the jumping surface facing up.
The jumping surface has the colored (usually
yellow) stripes sewn around the edge.
Figure 11: Placing the mat inside the frame
Figure 12-A: Attaching the mat to the rods
WARNING: Treat any loaded rod
with caution until you are sure it is
properly installed or uninstalled.
Keep your face well clear of any
loaded rod.
Tip: Make sure the
safety clip in the
mat-edge socket
has closed behind
the ball. If the ball is
properly installed, you
should not be able to
slide the ball out of
the mat socket
(Figure 11-B).
Figure 12-B: Safety clip operation. Clip secured (left);
Clip released (right)
clip
ball movement
joint next to be connected
To Next Page
Loading...