18) Connect a water connector to
the other side of the pre-plumb.
The side leading back into the
home. Ensure it is fully tightened.
Questions? Call (800)-589-5592 7
19) Connect the other end of the
corrugated pipe to the outgoing
side from the well water filter.
Ensure it is fully tightened.
Installing the Drain Line
21) Remove the blue lock tab
securing the drain valve in place.
22) Pull the drain valve straight
out.
23) Slide a hose clamp over an
end of one of the provided drain
lines.
This step will require the materials listed below
20) Locate the drain valve on the
left side of the well water filter
head. It is a compression
connection.
50’ Drain Line
Hose
Clamp
Zip Ties
Well Water Filter System
To Next Page
Loading...
Need help?
General
