© 2021 SPT Labtech Ltd
48
If user check the “Use Auto Depth”, the shuttle will lift automatically to the de ed
depth when perform Aspirate, Dispense, Empty/Blowout, and Mix. The height it lifted
is de
ed from Plate Training. If disable this, user would have to lift the shuttle
manually to the appropriate height, or hole the plate manually right below the tips,
then select the desired function.
If there are liquid inside the tips, select once will empty the liquid. Select the second
time will blow the excessive air out of the tip. If there are no liquid inside the tips,
select once will perform Blow Out function.
This function can be operated only when there’s liquid left inside the tips. This is
usually being used before running a protocol while the tips are not empty.
Select “Reset Pro le” will reset the current de ed pro le.
This is one of the ways to open and close clamp to change head. Another way is by
pressing the Tips Load/Unload button located on the front bottom left side.
To Next Page
Loading...