11
SPARCIN 9 / SPARCIN 9C
5. ACCESSORIES FOR MANUAL PLASMA CUTTING
There are a number of accessories available for SPARCIN and SPARCON cutting systems
equipped with hand torch.
Plasma gouging
All SPARCIN and SPARCON systems, except SPARCIN 5/, have gouging capability. By
fitting the torch with nozzle extension, gouging nozzle (2,2 mm for <80 A, 3,0 mm for >80A),
and protective cup for gouging (see torch parts lists) a powerful tool for gouging is obtained.
20 mm nozzle extension set
As an accessory there is a set of 20 mm nozzle extension, extended electrode and extended
protective cup. This is useful for cutting in narrow places, corners, etc.
Contact cutting nozzle
By dragging the nozzle directly against the work piece a good cut quality can be obtained in
material thickness up to 4 mm. Note that contact cutting is only allowed with cutting current
up to 40 A.
Cutting wagon
For both SPARCUT XL (art. No. 299028) and DURACUT (art. No. 299030) there is a four-
wheel cutting wagon available.
Circle cutting attachment
A circle attachment for DURACUT (art. No. 299079) and SPARCUT XL (art. No. 299082)
for cutting radius between ca. 100 and 450 mm.
Distance cutting guide
For all hand torches there are two different types of distance cutting guides, art. No. 199107
and 199124. See the torch parts lists for more information.
To Next Page
Loading...