EasyManua.ls Logo

SPX FLOW Hankison DH-260 User Manual

SPX FLOW Hankison DH-260
24 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
1
PRESSURE-SWING
DESICCANT TYPE
COMPRESSED
AIR DRYERS
7610.479.9 1/22/97
IMPORTANT:
READ PRIOR TO STARTING THIS
EQUIPMENT
A.
UNPACKING
This shipment has been thoroughly checked,
packed and inspected before leaving our plant.
It was received in good condition by the
carrier and was so acknowledged.
1. Check for Visible Loss or Damage. If this
shipment shows evidence of loss or damage
at time of delivery to you, insist that a notation
of this loss or damage be made on the delivery
receipt by the carrier’s agent.
2. Check for Concealed Loss or Damage. When a
shipment has been delivered to you in
apparent good order, but concealed damage is
found upon unpacking, notify the carrier
immediately and insist on his agent inspecting
the shipment. Fifteen days from receipt of
shipment is the maximum time limit for
requesting such inspection. Concealed
damage claims are not our responsibility as
our terms are F.O.B. point of shipment.
B.
MOVING CAUTION:
Do not lift by piping. Use lifting lugs or fork lift.
1. Pressurized devices: This equipment is
a pressure containing device. Do not
exceed maximum operating pressure as
shown on equipment serial number tag.
Make sure equipment is depressurized
before working on or disassembling it
for service.
2. Electrical: This equipment requires
electricity to operate. Install equipment
in compliance with national and local
electrical codes. Standard equipment is
supplied with NEMA 4, 4x electrical
enclosures and is not intended for
installation in hazardous environments.
Disconnect power supply to equipment
when performing any electrical service
work.
3. Breathing Air: Air treated by this
equipment may not be suitable for
breathing without further purification.
Refer to OSHA standard 1910.134 for
the requirements for breathing quality
air.
GENERAL SAFETY
INFORMATION
MODEL RATED FLOW DESIGNATED AS MODELS
DH-25 25 SCFM 25
DH-45 45 SCFM 45
DH-6000 60 SCFM 60
DH-80 80 SCFM 80
DH-115 115 SCFM 115
DH-165 165 SCFM 165
DH-260 260 SCFM 260
DH-370 370 SCFM 370
DH-450 450 SCFM 450
DH-590 590 SCFM 590
DH-750 750 SCFM 750
DH-930 930 SCFM 930
DH-1130 1130 SCFM 1130
DH-1350 1350 SCFM 1350
DH-1550 1550 SCFM 1550
DH-2100 2100 SCFM 2100
DH-3000 3000 SCFM 3000
DH-4100 4100 SCFM 4100
DH-5400 5400 SCFM 5400
®
Instruction Manual
DH Series
SERVICE DEPARTMENT (724) 746-1100

Questions and Answers:

SPX FLOW Hankison DH-260 Specifications

General IconGeneral
BrandSPX FLOW
ModelHankison DH-260
CategoryDehumidifier
LanguageEnglish

Summary

GENERAL SAFETY INFORMATION

IMPORTANT: EQUIPMENT START-UP GUIDANCE

Unpacking and Damage Inspection

Inspect shipment for visible or concealed loss or damage.

MINI INSTRUCTIONS FOR HANKISON DH SERIES

Installation Procedures Overview

Steps for installing the compressed air dryer unit.

Start-Up Sequence and Settings

Steps for safely starting and configuring the dryer.

HANKISON DH SERIES DRYER DESCRIPTION

Dryer Function and Operating Principle

How the dual-tower regenerative desiccant dryer works.

DH SERIES DRYER OPERATION DETAILS

Dryer Air Flow and Tower Switching

Detailed description of air paths and tower alternation.

COMPRESSED AIR DRYER INSTALLATION

Location and System Integration

Optimal placement of the dryer in the air system.

Operating Condition Requirements

Required air pressure, temperature, and ambient conditions.

ELECTRICAL CONNECTIONS AND POWER

Power Supply Wiring

Wiring instructions for standard and APS units.

DRYER OPERATION AND CONTROL

Initial Start-Up Procedure

Setting controller and initial start-up steps.

START-UP ADJUSTMENTS AND MODES

Purge Rate Valve Adjustment

Setting the purge rate valve for optimal performance.

OPERATIONAL CHECKPOINTS FOR DRYERS

Standard Unit Operational Checks

Verifying power, indicators, purge flow, and alarms.

MONITORING DRYER PERFORMANCE

DRYER DESIGN PARAMETER VERIFICATION

DRYER MAINTENANCE PROCEDURES

Desiccant Replacement Guide

Step-by-step instructions for replacing desiccant material.

MAINTENANCE AND TESTING PROCEDURES

Related product manuals