EasyManua.ls Logo

SPX FLOW TG GP185-125 - User Manual

SPX FLOW TG GP185-125
88 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
INSTRUCTION MANUAL
ORIGINAL INSTRUCTIONS
READ AND UNDERSTAND THIS MANUAL PRIOR TO OPERATING OR SERVICING THIS PRODUCT.
TopGear GP
INTERNAL GEAR PUMPS
A.0500.451 – IM-TG GP/07.02 EN (03/2016)

Table of Contents

Questions and Answers

  • J
    jacqueline81Aug 23, 2025
    Why SPX FLOW TG GP185-125 has no flow?
    • R
      robinsonjuliaAug 23, 2025
      If your SPX FLOW Water Pump has no flow, it might not be priming due to several reasons. The suction lift could be too high. Reduce the difference between the pump and suction tank level, or increase the suction pipe diameter, or reduce the length and simplify the suction pipe. Check for air leaks in the suction line and repair them. If the viscosity is very low, increase the pump speed and reduce axial clearance. Ensure the suction strainer or filter is clear. Verify the pump casing is correctly installed. Finally, check the motor's rotation; for 3-phase drivers, switch two connections, or change the suction and discharge opening, but be careful to check the location of the safety relief valve.
  • D
    Danielle WashingtonNov 5, 2025
    What to do if SPX FLOW Water Pump stalls or has irregular flow?
    • C
      Charles WilsonNov 6, 2025
      If your SPX FLOW Water Pump is stalling or experiencing irregular flow, several issues could be the cause. Check if the liquid level in the suction tank is too low and correct the liquid supply or provide a level switch. The pump output might be too high; if so, reduce the pump speed or install a smaller pump, or install a bypass line with a check valve. Air could be getting sucked in; repair any leaks in the suction line, check or replace the shaft seal, check or provide a quench on the shaft seal, or connect plug Bb to the pump discharge to increase pressure in the sealing box. Cavitation could also be the issue; reduce the difference between the pump and suction tank level, increase the suction pipe diameter, or reduce the length and simplify the suction pipe. Finally, the liquid may be...

Summary

Safety

General Safety Precautions

General safety precautions and warnings for pump operation and maintenance.

Pump Units

General Technical Information

Operating Principle

Explains how the internal gear pump functions step-by-step.

Main Characteristics

Pressure

Internals

Maximum Torque

Specifies maximum allowable torque for pump shaft and rotor material combinations.

Shaft Sealing

Safety Relief Valve

Relative Adjustment

Instructions for adjusting the opening pressure of the safety relief valve.

Installation

Instructions for Start-up

General and Cleaning

General procedures and cleaning steps before starting the pump.

Initial Start-up Checklist

A comprehensive checklist for initial pump start-up procedures.

Start-up and Shut-down

Procedures for safely starting and shutting down the pump.

Abnormal Operation

Guidance on handling abnormal operations and troubleshooting.

Trouble Shooting

Common Symptoms and Causes

A guide to identifying and resolving common pump problems and their causes.

Maintenance Instructions

General and Preparation

General guidelines and preparation steps for performing pump maintenance.

Draining of Fluid

Procedure for safely draining fluids from the pump.

Clearance Adjustment

Instructions for adjusting axial clearance in the pump.

Instructions for Assembly and Disassembly

Anti-Friction Bearings

Procedures for handling, disassembling, and assembling anti-friction bearings.

Electrical Heating

Sectional Drawings and Part Lists

Dimensional Drawings

SPX FLOW TG GP185-125 Specifications

General IconGeneral
BrandSPX FLOW
ModelTG GP185-125
CategoryWater Pump
LanguageEnglish

Related product manuals