Need help?Do you have a question about the SPX Radiodetection Tx-10 and is the answer not in the manual?
General| Output Power | 10 Watts |
|---|---|
| Ingress Protection | IP65 |
| IP Rating | IP65 |
| Operating Modes | Clamp |
| Power Source | Rechargeable battery |
| Battery Type | Lithium-ion |
| Operating Temperature | -20°C to +50°C |
Details short and long press actions for locator keys to navigate menus and perform functions.
Details short and long press actions for transmitter keys to navigate menus and perform functions.
Step-by-step guide to running a Self-Test on the locator for integrity checks.
How to use the transmitter to recommend a locate frequency by measuring utility impedance.
Connect transmitter directly to pipe/cable using leads for tracing.
Place transmitter on ground over survey area to induce signal.
Use an optional clamp to apply signal to insulated live wires.
Use harmonic signals on power networks to identify single vs. multiple cables.
Details the 5 different locate modes: PEAK, PEAK+, GUIDANCE, BROAD PEAK, NULL.
How to use a clamp when direct connection or induction is unsuitable.
Using an A-Frame accessory to detect cable/pipe insulation faults.
Steps to enable or disable the Bluetooth wireless connection module.
Lists requirements for pairing: RD8100 locator and compatible Bluetooth device.
Steps to initiate and complete the pairing process between locator and PDA.
Explains iLOC for remote control and its requirements (Bluetooth transmitter).
Recommends annual servicing and calibration at Radiodetection or approved centers.
To Next Page
