Need help?Do you have a question about the SPX Radiodetection RD7000+ and is the answer not in the manual?
General| Category | Cable and Pipe Locator |
|---|---|
| Operating Temperature | -20°C to +50°C (-4°F to +122°F) |
| Display | LCD with backlight |
| Operating Frequencies | 512 Hz, 640 Hz, 8 kHz, 33 kHz, 65 kHz |
| Depth Accuracy | ±5% (typical) |
| Current Measurement Accuracy | ±5% (typical) |
| IP Rating | IP54 |
Guidance before operating the RD7000+ system.
Essential safety precautions for using the RD7000+ system.
Important general notices regarding locator performance.
Information regarding battery types and handling.
Guidelines for proper battery disposal.
Details the content and purpose of the operating manual.
Information on obtaining further documentation.
Overview of the RD7000+ locator and transmitter system.
Provides a section-by-section overview of the manual's content.
General safety advice for operating the RD7000+ system.
Details the features, keypad, and screen icons of the locator.
Details features, keypad, and screen icons of transmitters.
Instructions for powering on, initial setup, and battery management.
Guide to using the menu system and available settings.
Explanation of frequency selection and signal transmission methods.
Description of TruDepth, SideStepauto, and Dynamic Overload Protection.
Information on StrikeAlert, audio settings, and backlight.
Explanation of adjusting power levels and using the boost function.
Discussion of different antenna modes for locating.
How to use the compass and trace lines for accurate location.
Methods for precisely locating buried utilities.
Techniques for locating unknown lines and performing sweeps.
How to measure the depth of buried utilities.
Information on measuring and interpreting current readings on lines.
Tips for dealing with signal interference during locating.
Guidance on establishing effective ground connections.
Techniques for applying signals using double-ended connections.
Using clamps to identify cables accessed at specific points.
Applying signals to cables using transmitter clamps.
Instructions for using sondes to trace non-metallic ducts and pipes.
Using stethoscope antennas to identify cables where clamps are inaccessible.
Using submersible antennas for tracing pipes and cables underwater.
Steps for preparing the transmitter and making connections for fault finding.
Procedure for locating cable sheath faults using the A-frame.
Information on registering the product and warranty coverage.
Overview of the PC application for managing the RD7000+.
Details on validating and retrieving calibration certificates for the RD7000+.
Instructions for updating the RD7000+ software.
Recommendations for maintaining the equipment's condition and longevity.
Key technical data for the RD7000+ locator and transmitter.
List of frequencies compatible with different RD7000+ models.
List of available accessories and their corresponding part numbers.
To Next Page
