At Home SPX Reformer Owner’s Manual12
Removing the Carriage
1. To remove carriage, remove pulleybars and place on the floor,
on either side of the aluminum rails.
3. Carefully slide carriage out of the aluminum rails keeping
carriage level until completely free of rails. Turn carriage over
ensuring rollers are secure and do not come in contact with
thefloor.
NOTE: Requires two people.
2. Using a Phillips screwdriver, remove stopper plates.
4. Place carriage face-down on the ground.
NOTE: Ensure carriage is placed on a soft surface that will not
damagethe vinyl.
Required Tool
Phillips Screwdriver
MAINTENANCE & REPLACING PARTS
To Next Page
Loading...