2
1.
Sit spreader
assembly on
hopper as shown.
2.
For stainless
steel models
remove nuts and
bolts that attach
front of hopper to
frame as indi-
cated, and then
insert Bump Bar
(3) into frame
assembly. Next,
re-insert bolts and
tighten nuts.
Tow Behind Frame Assembly
Note: For black frames remove nuts and bolts
that attach front hopper to frame. Push
bump bar into frame (Black bump bars do
not have holes drilled in them). Re-insert
bolts and nuts and tighten against the
bump bar
.
1
Tools you will need:
Medium Sized Screwdriver
7/16” & 3/8” wrenches
Hammer
Pliers
Parts for Models:
76-22 96-22
78-22 98-22
• (3) 1/4 - 20 x 1 1/2" 55 bolt
• (8) 1/4 - 20 55 hex nut
• (3) 1/4 - 20 x 1 3/4" 55 bolt
• (1) 1/4 - 20 x 2 3/4" 55 bolt
• (1) 1/4 - 20 x 1" bolt
• (2) 10 - 24 x 1 1/2" 55 bolt
• (2) 10 - 24 55 lock nut
• (2) handle grips
• (1) agitator wire
• (4) handle/tow bar braces
• (1) cable clamp
• (1) felt washer
• (1) manual
• (1) 1/4 - 20 x 1" 55 bolt
For Quick and Easy Assembly - First Read Entire Procedure
Then Follow Carefully The Step by Step Instructions
Assembly Instructions
Parts you will use:
To Next Page
Loading...
