Why does my Square Scrub Ultrasonic Jewelry Cleaner keep tripping the circuit breaker?
The circuit breaker may trip due to low voltage. First, allow the motor to cool. Also, try eliminating any extension cords and locate the power cord closer to the work site. If the problem persists, have an electrician check the voltage.
What to do if my Square Scrub Doodle Scrub EBG-9 Ultrasonic Jewelry Cleaner won't start?
If your machine won't start, first check the power source connection and the lighted plug. If the connection is fine, the voltage may be too low; in that case, have an electrician check the outlet. If neither of these resolves the issue, the switch may be defective.
Why does my Square Scrub Doodle Scrub EBG-9 Ultrasonic Jewelry Cleaner run erratically?
Erratic operation can be caused by low voltage due to an excessively long or undersized extension cord. Try using a 10-gauge extension cord. If the issue continues, the start switch or motor may be defective due to low voltage.
Why is my Square Scrub Ultrasonic Jewelry Cleaner machine noticeably louder than when originally purchased?
If the machine is louder than usual, it could be due to worn rubber isolators. Replacing the isolators should resolve this issue.
How to fix Square Scrub Doodle Scrub EBG-9 Ultrasonic Jewelry Cleaner that pulls hard to one side?
If the machine pulls hard to one side, it could be due to a worn pad. Try rotating the pad 180 degrees. Also, worn rubber isolators may cause this issue. In this case flip the pad over, replace the pad or replace the isolators.
Why does my Square Scrub Doodle Scrub EBG-9 Ultrasonic Jewelry Cleaner stop and then work fine after a few minutes?
If the unit stops and then works fine after a few minutes, it might be due to using the incorrect pad. Ensure you are using the correct pad.
Overview of the EBG-Series machine and its quality.
Details on grounding the machine to prevent electric shock.
Outlines required maintenance tasks based on frequency.
Explains warning symbols and provides contact info for assistance.
Outlines product liability and user responsibilities.
Basic safety tips for installation, operation, and maintenance.
Covers indoor use, prohibitions, and required personal protective equipment.
Details electrical safety and warnings around flammable materials.
States the appliance is not for picking up hazardous dust.
Steps for safely moving and carrying the machine.
Step-by-step guide for machine operation.
Provides sound power and vibration total levels.
Illustrates the proper and improper ways to attach the handle.
Addresses issues like intermittent stopping, startup failures, and erratic running.
Solutions for machine pulling aside or excessive noise from worn parts.
Details coverage, disqualifications, and wear item exceptions.
Lists major components like Switch, Handle, Base, and Grip Face with part numbers.
Describes various pads for different cleaning and buffing tasks.
General| Brand | Square Scrub |
|---|---|
| Model | Doodle Scrub EBG-9 |
| Category | Ultrasonic Jewelry Cleaner |
| Language | English |
To Next Page