EasyManuals Logo

Squirrel CRUX 2 3R User Manual

Default Icon
12 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #3 background imageLoading...
Page #3 background image
2
3. You MUST place enough canopy bulk in the upper section of the container to create adequate flap
tension. A significant amount of canopy bulk should be above the top closing loop. Leaving some empty
space at the top of the container will help to keep the top section low-profile and wrinkle-free, but
you must ensure that enough canopy bulk is high enough in the container to make the top edges
of the side flaps lay tightly and securely. Flying at high airspeeds may cause improperly seated or
inadequately tight side flaps to catch air and possibly open the pin cover flap.
4. The second fold should be at the bottom of the container. Leave the parachute bridle attachment point
exposed so the bridle route is clean.
5. When your CRUX 2 3R is closed, the main pin cover flap should be cleanly seated. Check your placement
of the packjob volume. It should be dispersed evenly from corner to corner and match the shape of the
container. If too much volume is directly under or around the top pin, the main pin cover flap may not seat
properly. Your canopy should be folded into a flat and rectangular configuration matching the container.
6. The small tuck tab MUST be placed below the flap as shown.
If the pack-job appears messy and disorganized, consider redoing it with improved technique.
Your CRUX 2 3R must be packed cleanly in order to function properly. If you are unsure, do not
jump it. Contact Squirrel immediately with any questions or concerns.
1 2
3 & 4 (Using Floorplate Loop)
5
6

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Squirrel CRUX 2 3R and is the answer not in the manual?

Squirrel CRUX 2 3R Specifications

General IconGeneral
BrandSquirrel
ModelCRUX 2 3R
CategorySports & Outdoors
LanguageEnglish