Squirrel CRUX 2 3R User Manual

LIGHT BUCKLES
The CRUX 2 3R features aluminum plate buckles. Be sure to assemble them correctly, and inspect
them before every jump. Webbing must pass around the middle bar of the small buckle. The entire
small buckle then passes through the hole in the larger buckle. Confirm that the webbing fold back
end is under (below) the large buckle’s outside edge.
Do not twist the leg strap before attaching buckles, and as with every other part of your equipment,
do a thorough pre-jump check to verify proper leg and chest strap assembly and routing.
The stopped ends of the leg straps provide up to 3000 lbs of resistance in the case of some mis-
routings.
See photos for GOOD and BAD routing.
NO
NO
YES
YES
8
MAINTENANCE
All load bearing parachute equipment must be stored properly away from corrosive materials,
solvents, moisture, sunlight, or any other element that may degrade materials.
Inspect 3-ring assembly including the white loop before every jump. It should not be frayed or
worn. All riser rings should be smooth and free of corrosion. All cables should slide without excess
resistance and be free of kinks or damage.
The cutaway cable should be lubricated with a light coating of food-grade silicone. Check the
cutaway cable frequently to ensure proper function.

Squirrel CRUX 2 3R Specifications

General

Brand	Squirrel
Model	CRUX 2 3R
Category	Sports & Outdoors
Language	English