Need help?Do you have a question about the SRAM RockShox Super Deluxe Flight Attendant and is the answer not in the manual?
General| Brand | SRAM |
|---|---|
| Model | RockShox Super Deluxe Flight Attendant |
| Category | Bicycle Accessories |
| Language | English |
AXS components are only compatible with other AXS components. Consult the compatibility map for details.
Explains Flight Attendant system components and pairing requirements.
Lists common and specialized tools, safety gear, lubricants, and fluids for installation.
Details the SRAM battery and charger components for the system.
Identifies and labels the parts of the Flight Attendant Control Module.
Explains the LED color coding for different modes and settings.
Identifies and labels the parts of the Rear Shock Module.
Identifies and labels the parts of the Pedal Sensor.
Details the RockShox AXS Controller and its components.
Details the SRAM AXS Rocker Controller and its components.
Describes the types of batteries used and their specific requirements.
Explains how LED indicators show battery charge levels for components.
Steps and notices for charging SRAM batteries.
Instructions on how to install batteries into suspension modules.
Step-by-step guide for installing the AXS Controller with an MMX clamp.
Step-by-step guide for installing the AXS Controller with a discrete clamp.
How to locate and record the AXS serial number for system identification.
Lists the steps to complete the setup process before first use.
Instructions on how to activate the Pedal Sensor before pairing.
Steps to initiate pairing with the Control Module.
Steps to pair the Rear Shock and Pedal Sensor.
Steps to pair an optional AXS Controller.
Guide to pairing other AXS components into the system.
How to set spring air pressure and adjust rebound damping.
Steps to prepare the bicycle and environment for calibration.
Guide for performing the vertical calibration process, including preparation and initial steps.
Guide for performing the tilt calibration process after vertical calibration.
Explains LED indicators for errors during vertical calibration.
Explains LED indicators for errors during tilt calibration.
Troubleshooting for calibration system time out errors indicated by red LEDs.
Troubleshooting for errors during calibration exit and rear shock detection.
Explains how bias adjustment affects suspension behavior in Auto Mode.
Steps for manually adjusting bias levels using the control module.
Instructions for setting Low Speed Compression for the front fork.
Instructions for setting Low Speed Compression for the rear shock.
Explains the electronically activated suspension settings (OPEN, PEDAL, LOCK).
Details how Auto Mode works and its primary function.
Illustrates different combinations of front and rear suspension positions in Auto Mode.
Steps to activate Manual Mode from the Control Module menu.
How to change suspension positions using buttons or controllers in Manual Mode.
How to activate Override Mode from the AXS Controller.
Details Override Mode behavior and how to return to Auto Mode.
Conditions for entering Safe Mode and how to exit it.
Troubleshooting steps for common Safe Mode causes and errors.
How to activate the system and switch between modes.
Instructions for suspension disassembly, service, and battery removal.
Recommended procedures for cleaning the system components.
Guidelines for storing components and removing batteries to preserve life.
Step-by-step guide for replacing the CR2032 battery in the AXS Controller.
Important notices regarding Pedal Sensor batteries and service.
Instructions for removing both non-threaded and threaded Pedal Sensors.
Step-by-step guide for replacing the AAA battery in the Pedal Sensor.
Steps for optional service, o-ring replacement, and greasing.
Final steps for assembling the Pedal Sensor after battery replacement.
Instructions for installing the non-threaded Pedal Sensor.
Instructions for installing the threaded Pedal Sensor.
Guidelines for proper battery disposal and replacement.
To Next Page