Care and storage
Only remove the QTS sleeve or tuning weights when making adjustments.
All parts should remain properly installed at all other times,
including when the club is in storage, to ensure that no foreign objects
or debris become lodged in the sleeve connection or screw holes.
1
Do not heat the QTS sleeve as it may damage the product.
4
Avoid adjusting the QTS sleeve when the temperature is below
-5˚C or above 45˚C, as it may damage the QTS sleeve.
5
6
When removing the QTS sleeve or tuning weights, be sure that you do
so in a clean location to ensure that no foreign objects or debris
become lodged inside.
Installing the tuning weight while there are foreign objects or debris
in the weight port may damage either the weight or the port, and also
may prevent proper installation or removal of the tuning weight.
It may even cause internal damage to the club head, adversely
affecting club performance.
2
If the QTS sleeve or weight ports become soiled with water, dirt,
or other debris, wipe them clean with a cotton swab or a soft,
clean and dry cloth.
3
19 20
To ensure a safe and satisfying golfing
experience, please be sure to follow these Important Precautions.
Important
Precautions
The manufacturer assumes no liability for injury or product damage due to failure to comply with the instructions herein.
Be sure to read the Important Precautions carefully and exercise appropriate care.
Please be aware that attempts to remove the QTS sleeve from
the shaft or intentionally disassembling it may not comply with
the manufacturer’s warranty.
* For information on manufacturer's warranty regulations,
please refer
to the owner's manual and warranty included with your golf club.
4
17 18
To ensure a safe and satisfying golfing
experience, please be sure to follow these Important Precautions.
Important
Precautions
The manufacturer assumes no liability for injury or product damage due to failure to comply with the instructions herein.
Be sure to read the Important Precautions carefully and exercise appropriate care.
Rules of Golf
You may not change the QTS sleeve position
or exchange weights during a round.
SRIXON Z Series clubs conform with R&A-approved Rules of Golf. However,
it is against the rules to modify club performance during a round by changing
the QTS sleeve position or exchanging weights to change the CG position,
as this breaches the Rules of Golf regulation 4-2a,
which states: “During a stipulated round, the playing characteristics of
a club must not be purposely changed by adjustment or by any other means.”
Before using
Carefully inspect the QTS sleeve and tuning weight prior to each round
of golf or practice session to confirm that they are properly secured.
If the tuning weight is not secured firmly in the weight port when
swinging the club during a game or practice session, there is
a possibility that the weight could fly off, injuring either you or a bystander.
1
Tighten until you hear a 'click'.
If you fail to properly secure the
sleeve, there is a possibility that
the head may come off in mid
swing, injuring either you or a
bystander.
2
Check to see that the QTS sleeve is properly secured.
Check to see that the tuning weight is locked securely in position.
Tighten until you hear a 'click'.
17 18
To ensure a safe and satisfying golfing
experience, please be sure to follow these Important Precautions.
Important
Precautions
The manufacturer assumes no liability for injury or product damage due to failure to comply with the instructions herein.
Be sure to read the Important Precautions carefully and exercise appropriate care.
Rules of Golf
You may not change the QTS sleeve position
or exchange weights during a round.
SRIXON Z Series clubs conform with R&A-approved Rules of Golf. However,
it is against the rules to modify club performance during a round by changing
the QTS sleeve position or exchanging weights to change the CG position,
as this breaches the Rules of Golf regulation 4-2a,
which states: “During a stipulated round, the playing characteristics of
a club must not be purposely changed by adjustment or by any other means.”
Before using
Carefully inspect the QTS sleeve and tuning weight prior to each round
of golf or practice session to confirm that they are properly secured.
If the tuning weight is not secured firmly in the weight port when
swinging the club during a game or practice session, there is
a possibility that the weight could fly off, injuring either you or a bystander.
1
Tighten until you hear a 'click'.
If you fail to properly secure the
sleeve, there is a possibility that
the head may come off in mid
swing, injuring either you or a
bystander.
2
Check to see that the QTS sleeve is properly secured.
Check to see that the tuning weight is locked securely in position.
Tighten until you hear a 'click'.
To Next Page
Loading...
