How to change tuning weights
1
Pull the torque wrench directly
up to remove the weight.
2 3
11 12
Hold the clubhead securely in one hand
and the custom torque wrench in the other.
Insert the custom torque wrench
straight into the hole in the center of
the tuning weight and rotate it
counterclockwise to unlock.
* If the weight is difficult to remove
lightly jiggle and pull the tuning weight
at the same time with torque wrench
still inserted.
Place the desired tuning weight on
the tip of the custom torque wrench,
insert it into the weight port,
and rotate it clockwise to lock.
Improper installation of the tuning weight may result in injury or product damage.
Do not use any tool other than the supplied torque wrench.
Also do not use the supplied torque wrench on any other products.
Hold both the custom torque wrench and the clubhead securely while exchanging the weights.
Ensure that the tip of the custom torque wrench is fully inserted
into the hole of the tuning weight.
Failure to tighten until you hear a 'click' may result in separation
of the club head or product damage.
Always tighten until you hear a 'click'.
To Next Page
Loading...
