Page | 3
Connecting to and setting up the Victron Energy Smart Solar Charge controller
MPPT 75 / 10
Ensure that initially only one solar panel is powered up for connection and setup before
powering the next one. This will enable you to setup the correct solar regulator and its
associated fleet number.
Download the Victron Connect which has this symbol.
Ensure your Bluetooth is on and open the application,
search Device list – Local – look for SmartSolar *****
MPPT 75/10.
Select the equipment you want to set up and wait while
it connects. Enter the default pin – 000000 and again
wait while it further connects.
If a prompt to update firmware appears then click yes.
You will then come across this message which is giving
you the opportunity to change the devices PIN code.
Select Change Pin Code and change it to the fleet
number provided to the solar assembly – all digits in the
fleet number starting with a 0 as it has to be a 6 digit pin
number.
To Next Page
Loading...