Ss Brewtech E-Kettle 304 User Manual

Page 4
PREASSEMBLY
Heat that comes into the contact with the ball valve or thermometer can cause damage to the
thermometer’s and/or ball valve’s interior seals. Always brew on a at, nonammable surface.
Never attempt to lift a kettle that contains hot liquid due to the risk of injury or scalding to yourself
or others. As a solution, utilize a wort pump to transfer hot liquids and avoid injury.
Before activating the heater element, always verify the element is fully submerged in water.
Dry ring the element will cause irreversible damage to the element coil and void the element’s
warranty. Prolonged dry ring can cause damage to the vessel and other components and can
result in personal injury or property damage.
Make sure that the unit is connected to a dedicated GFCI circuit.
Wear proper PPE (Personal Protective Equipment) when using the equipment. This would
include protective eyewear, gloves and apparel that would aid in prevention of scalding from
boiling water.
Before plugging in the kettle element to the controller, ensure that both the heater activation
button as well as the side mounted on/off switch are not currently engaged. This will prevent
accidental dry ring.
WARNING
Off Position
- Button is not recessed
- No indicator light
On Position
- Button is recessed
- Red indicator light
Side Mounted “ON/OFF” Switch in “OFF” Position
ACTIVATION BUTTON
O
F
F
O
N
O
F
F
O
N

Ss Brewtech E-Kettle 304 Specifications

General

Brand	Ss Brewtech
Model	E-Kettle 304
Category	Brewing Systems
Language	English