Page 6
SENSOR: SETTINGS & CALIBRATION (CONTINUED)
CALIBRATION
Before use, it is important to ensure that your sensor is properly calibrated. There are several ways of
calibrating a temperature sensor, but the simplest way is to use an ice-water mixture. When you insert
your sensor into an ice-water mixture, it should read 32°F (0°C). Perform the “ice method” of calibration
and document the offset, if any. You can then set a temperature offset on the controller to reect
this variation.
Press the “Level Key” for less than 1 second, and then use the “Mode Key” until you see “Cn5”. Next
use the “Up” or “Down” Key to change the temperature offset.
Press the “Level Key” for less than 1 second to exit to the main screen.
Up KeyLevel Key
Down KeyMode Key
No. 1 Display
Temperature Unit
No. 2 Display
To Next Page
Loading...
