Page 6
BEFORE YOU BREW - SYSTEM ASSEMBLY
1. Think about where you want to locate your Brew Bucket or Chronical series fermenter, where you will
place the controller, and where you will place your chilled water source (whether that is an ice chest,
chilled corny keg in a cooler, glycol chiller, etc.).
2. Start by removing your fermenter’s ttings, lid, and neoprene jacket if it is already installed, and then
place the fermenter upside down on a surface that won’t mar the upper rim of the body. This will make
it easier to insure the heater is orientated correctly on the cone while you reinstall the neoprene jacket.
3. Place the low-wattage heater onto the cone so that it doesn’t interfere with the welded ttings, and
maximizes surface area contact with the fermenter body. Use a zip-tie to hold the heater’s shape until
the neoprene insulating jacket is reinstalled over the fermenter. The neoprene jacket will insure that the
heater is held tightly to the cone to maximize efciency.
3. Extend the wire from the low-wattage cone heater out of the bottom of the neoprene jacket.
4. Next, install the immersion coil and thermowell into the lid as shown (Note: there are extra o-rings
supplied; you only need to use the o-rings on the wort side of the lid).
ASSEMBLY INSTRUCTIONS
Silicone Stopper
Lock Nut
O-Ring
Immersion Coil
Thermowell
To Next Page
Loading...
Need help?
General