7
41. Remote Input –
Black Out and Full On may be controlled by a remote control using a standard 1/4” stereo jack.
V. OPERATIONS
1. Programming
1.1 Record Enable
1) Press and hold down the Record button.
2) While holding down the Record button, tap the Flash buttons 1, 6, 6 and 8 in sequence.
3) Release the Record button, the Record LED lights up, now you can begin programming your
chase patterns.
NOTE:
The rst time you turn on your unit, the default setting of the Record Code is Flash buttons 1, 6, 6
and 8.
You may change the Record Code to protect your programs.
1.2 Security for Your Programs
To protect your programs from any editing by others, you may change the Record Code.
1) Enter current Record Code (Flash buttons 1, 6, 6 and 8).
2) Press and hold down the Record and Edit buttons at a time.
3) While holding the Record and Edit buttons, tap the desired Flash button to enter a new Record
Code.
The Record Code consists of 4 Flash buttons(the same button or different buttons), be sure your
new Record Code consists of 4 Flash buttons.
4) Enter your new Record Code a second time, all channel LEDs and scene LEDs will ash three
time, now the Record Code is changed.
5) Exit Record mode. Tap the REC. EXIT button while pressing and holding down the Record but-
ton, release the two buttons at a time, the Record mode is disengaged.
IMPORTANT!!!
Always remember to exit Record mode when you won’t continue your programming, otherwise you
may lose control of your unit.
NOTE:
The second time you enter your new Record Code different from that of the rst time, the LEDs will
not ash, which means you’ve failed to change the Record Code.
When you enter a new Record Code the rst time, provided that you want to cancel the new Re-
cord Code, press and hold down the Record and Exit buttons at a time to
To Next Page
Loading...