SSV Works RZ4-2KRC User Manual

•
•
RZ4-2KRC
SSV WORKS, 201 N. Rice Ave Unit A, Oxnard, CA 93030
www.SSVworlls.com I Phone: 818-991-1778 I Fax: 866-293-6751 Polaris RZR XP Turbo S 2-Speaker Kit
WARRANTY INFORMATION:
All SSV Works enclosures are covered by a limited lifetime warranty against defects In
material or workmanship. All SSVWorks Electronics are covered by a limited 1 year warranty
against defects In material or workmanship. All Kicker Speakers are covered by a limited 1
year warranty against defects in material or workmanship. All Kicker Amplifiers are covered by
a limited 2 year warranty against defects in material or workmanship. Labor for replacement
of defective components is not covered. Contact SSV Works for further warranty Information.
TOOLS NEEDED FOR INSTALLATION
Please read and understand these
instructions completely before
installation to avoid possible injury, or
damage to the accessory or vehicle.
- T30 & T40 Torx Socket - 4mm & 5mm Allen Wrench - Drill with 13/64", 1/8", 1/4" -Wire Crimpers - Scribe or Marker
- 10mm and 5.5mm Socket
& Rachet or Wrench
PARTS LIST IMAGES
1. Amp PowerWire
5. Amp Tray Base Bracket
9. Fuse Holder with 40A Fuse
- #2 & #3 Phillips Screwdriver
& 1/2" Drill bits
- Wire Strippers - Utility Knife
- Panel removal tool
2. Front B-H1149 Speaker Wire
6. M6 x 1.0 Screws and
Washersx2
10. BatteryTenninal Cable
3. Rear B-H1151 Speaker
Expansion
Triangular
end
7. Self-TappingScrewx 1
4. Amp Tray with pre-loaded
Kicker Amplifier
<
.;c
8. Zip Ties X 5
1

SSV Works RZ4-2KRC Specifications

General

Brand	SSV Works
Model	RZ4-2KRC
Category	Car Speakers
Language	English

Summary

Warranty and Tools

Warranty Information

Details warranty coverage for enclosures, electronics, and speakers.

Installation Tools Required

Lists necessary tools for the installation process.

Panels and Dash Disassembly

Driver Seat Removal

Instructions for safely removing the driver's seat.

Battery Disconnection

Procedure to disconnect the negative battery terminal.

Center Console Removal

Steps to remove the center console and related harnesses.

Hood and Dash Panel Removal

Instructions for removing the hood and the main dash panel.

Wiring and Cable Routing

Firewall Grommet Access

Guidance on accessing and utilizing the firewall's rubber grommet.

Routing Power and Speaker Wires

Instructions for routing amp power and speaker wires through the vehicle.

Amplifier Tray Installation

Tray Base Bracket Mounting

Attaching the amp tray base bracket to the chassis using factory bolts.

Tray Pilot Hole Marking

Marking the location for a pilot hole on the amplifier tray.

Amplifier Tray and Connections

Drilling Pilot Hole and Securing Tray

Drilling a pilot hole and securing the amp tray with a self-tapping screw.

Amplifier Input Connections

Connecting the amplifier's front and rear inputs to factory harnesses.

Battery Power and Ground Connections

Fuse Holder Preparation

Preparing the fuse holder by modifying its cover and extracting screws.

Ground Cable Installation

Installing ground cables onto the negative battery terminal.

Power Cable Installation

Installing power cables onto the positive battery terminal.

Fuse and Cable Securing

Inserting the fuse and securing all cabling with zip ties.