SSV Works BR-2B65U User Manual

PARTS LIST IMAGES
TOOLS NEEDED FOR INSTALLATION
BR-2B65U
2021+ Ford Bronco, 2 Door
6.5” Rear Speaker-Pod Add-Ons
WARRANTY INFORMATION:
All SSV Works enclosures are covered by a limited lifetime warranty against
defects in material or workmanship. All SSV Works Electronics are covered by a
limited 1 year warranty against defects in material or workmanship. All Kicker
Speakers are covered by a limited 1 year warranty against defects in material or
workmanship. All Kicker Amplifiers are covered by a limited 2 year warranty
against defects in material or workmanship. Labor for replacement of defective
components is not covered. Contact SSV Works for further warranty
information.
Please read and understand these
instructions completely before installation to
avoid possible injury, or damage to the
accessory or vehicle.
!
SSV WORKS, 201 N. Rice Ave Unit A, Oxnard, CA 93030
www.SSVworks.com | Phone: 818-991-1778 | Fax: 866-293-6751
(x2) M6 x Screw
Passenger Rear Door Pod
Bracket Pack
Driver Rear Door Pod
(x2) M6 Washer
• T25, T30 Torx Driver
• #1 Phillips Screwdriver
(x2) #1 Phillips Screw
BR-2B65U
2023 SSV Works, Oxnard, Ca 93030 BR-2BR65 Rev. A. 4-24-23

SSV Works BR-2B65U Specifications

General

Size	6.5 inches
Impedance	4 Ohms
Sensitivity	90 dB
Compatibility	Universal
Woofer Composition	Polypropylene
Power Handling (Peak)	200W
Frequency Response	20Hz to 20kHz
Power Handling (RMS)	100 Watts

Summary

Warranty Information

Tools Needed for Installation

Parts List Images

Disassembly

Remove bottom speaker enclosure screw

Locate and remove the screw at the bottom of the speaker enclosure during disassembly.

Remove bracket screws

Remove screws securing the bracket to the vehicle and enclosure.

Installation

Secure driver side bracket

Attach the driver side bracket to the driver side pod using factory screws.

Connect pod to harness

Position the pod at its mounting location and connect the factory harness.

Attach harness cover

Snap the speaker pod harness cover onto the pod, ensuring harness exits relief.

Secure harness cover

Use the provided Phillips screw to fix the harness cover in place.

Loosely attach pod bottom

Loosely connect the bottom of the pod to the vehicle frame using M6 screw and washer.

Install factory bolts

Secure the pod to the vehicle by installing the two factory bolts.

Tighten pod bottom screw

Fully tighten the bottom screw that secures the pod at its base.